Owner's Manual

21
Fig. 21
13. To remove the rear bushing, place the auger into the
evaporator and use it to gently tap and dislodge the
rear bushing housing (Fig.21).
Evaporator reassembly Fig. 22
1. Remove and inspect O ring seal. Replace if
damaged in any way.
2. Place rear bushing into evaporator.
3. Install the three bolts: partially tighten each bolt,
alternating bolts until the rear bushing is fully seated
and properly aligned (Fig.22).
4. When fully seated, remove the bolts.
Fig. 23
5. Install the reservoir with three bolts (Fig.23).