Quick Start Manual

110 Series Ice and Water Dispensers 11
10. Apply a thick bead, approximately. 1/4" (6mm)
diameter, of NSF listed silicone sealant (Dow-
Corning RTV-732 or equivalent) 1/4" (6mm) inside
marked outline of dispenser.
11. Carefully position dispenser on counter.
12. Remove four screws securing splash panel to front
of dispenser and gently lay splash panel on counter.
(Water line to solenoid valve can be disconnected
from water inlet valve by pushing on ring at end of
inlet  tting while pulling on tubing.)
13. Secure dispenser to counter with four 3/8" bolts
(supplied by others).
14. Smooth excess sealant around outside of dispenser.
15. Run water station line from back of dispenser
through utility knock-out (Figs. 4, 5) or up through
counter cut-out. Connect water supply line to 3/8"
FPT, (Fig. 3J)  tting on utility  ange at bottom of
dispenser.
16. Remove 3/4" drain connection plug from either
 tting at rear of dispenser, (Fig. 1K) or internal
 tting, (Fig. 3L), as appropriate. Connect and run
a dedicated drain line to wall or  oor drain. An air
break should be provided.
If dispenser is equipped with a top mount,
water-cooled ice machine complete steps 17
through 20. If equipped with a top mount,
air-cooled ice machine proceed to step 21.
17. Connect ice machine water supply line to 3/8" FPT
water inlet, (Fig. 4M).
18. Connect ice machine drain line to 3/4 MPT drain
connection (Fig, 4N).
19. If ice machine is water-cooled, connect water-cooled
condenser supply line to 3/8" FPT condenser  tting
on back of dispenser (Fig. 4R).
Note: Do not run condenser supply water through
ice machine water  lter system.
20. Connect condenser drain line to 3/8" FPT  tting on
back of dispenser (Fig. 4P).
Important: Do not connect condenser drain line to
any other drain lines.
21. Proceed with either RIDE or top-mounted ice
machine connection instructions, as appropriate.
Fig. 4 – Rear connections, countertop models with
integral ice machines
Fig. 5 – Rear connections, countertop models with RIDE
ice machines
access panel
access panel
(M) 3/8" FPT
ice machine water inlet
(R) 3/8" FPT condenser inlet
(water-cooled only)
(P) 3/8" FPT
condenser outlet
(water-cooled only)
(N) 3/4" MPT
ice machine drain
(H) water station knock-out
(G) ice transport tube knock-out
(H) water station knock-out
3/4" FPT dispenser
drain
3/4" FPT dispenser
drain