Manualshelf

Owners Manual

ManualsBrandsFollett ManualsCommercial Countertop Ice Makers and Dispensers7CI100A-IW-CF-ST-00 15" 7 Series Countertop Ice and Water Dispenser with 125 lbs. Daily Production, 7 lbs. Storage Capacity, Internal Filter and Agion Silver-Based Antimicrobial Product Protection in Stainless Steel
12345678910
7CI100A/7FS100A, 15CI100A/15FS100A 9
Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1. If installing optional 4" Leg Accessory (item# 00956300), place a
5" (12.7 cm) spacer underneath the dispenser to ease installation.
2. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
3. Screw each leg into chassis (Fig. 3).
Fig. 3
Freestanding Installation
Installation instructions for countertop model may be found on Countertop
Installation on page 8.
1. A clearance of at least 3" (7.62 cm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig.4).
2. Rough-in the electrical service and water line.
§ Electrical: 115 V, single phase, 15A receptacle required. The dispenser
has an integral 8 ft (2.4 m) cord and plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" MPT inlet.
NOTICE!
If installing optional Leg Accessory, complete those steps before
proceeding. See page 11 for Leg Accessory instructions.
Fig. 4
spacer
5" (12.7 cm)
min.
freestanding models
minimum 3" (7.62 cm)
clearance required