Installation Instructions

6
self-contained DROP-IN • RIDE Technology
12"
(304,8mm)
min.
4"
(101,6mm)
➌
➍
➓
➑
➋
➏
➎
➊
➐
➐
➒
Hot Water
160 F (71 C)
Prepare the dispenser.
3
Dispenser preparation
• Determine best route for ice transport tube run. Note: 12" (304,8mm) clearance is required.
• Drill 1 3/4" (44,5mm) hole through either side of dispenser
➊
• Install gasket
➋
onto bulkhead tting
➌
• Attach bulkhead tting with at up
➍
and tighten bulkhead nut
➎
• Position and secure nut locking plate
➏
with supplied screws
• Verify installation of O-ring on stainless steel ice transport tube coupling
➐
• Insert stainless steel ice transport tube coupling
➐
into bulkhead tting and secure with coupling
cap
➑
• Heat end of transport tube in cup of 160 F (71 C) hot water to soften and spread with pliers
➒
before making connection to ease assembly
• Attach ice transport tube to coupling with supplied hose clamp
➓
2.1
Dispenser preparation
3.1