Maestro Plus™ Ice Machine with RIDE™ Technology Installation Instructions for Ice Storage Bin MCD425A/W BS, MCE425A/W BS, MME425A/W BS, MCC425A/W BS, MMC425A/W BS (See model number configurator on page 2 for details.) Order parts online www.follettice.com self-contained 801 Church Lane • Easton, PA 18040, USA Toll free (877) 612-5086 • +1 (610) 252-7301 www.follettice.
Chewblet® Ice Machine Model Number Configurations MC Machine MC Maestro Plus Chewblet (425 Series) MF Maestro Plus™Flake P Replacement R Symphony Pus RIDE Ice Machine Voltage C 425 Series C 208-230/60/1 Self-contained D 115/60/1 Self-contained E 230/50/1 Self-contained A V S Application Condenser A Air-cooled, self-contained 425 up to 454 lbs W Water-cooled, (206kg) self-contained V Vision™ Configuration S RIDE® (RIDE remote ice delivery equipment) H Harmony™ B Ice storage bin J T Top-mou
Contents Unpack.........................................................................................................................................................................4 Unpack Ice Machine...............................................................................................................................................4 Site Preparation...................................................................................................................................................
1. Unpack Carefully unpack and inspect the contents of your Follett ice machine. 1.
2. Site Preparation Provide drainage, potable water supply and electrical power to within 6 feet (2m) of ice machine in accordance with local and national codes. Outdoor installation is not recommended and will void warranty. 2.1 Installation site requirements ➊ ➋ 115 V ±5% 230 V ±10% 220 V ±10% Electrical 115 V NEMA 5-15 ➌ ➍ 1/4" 1' ➊ WARNING! §§ This appliance should be connected by a qualified person in accordance with application codes.
3. Bin Top Preparation 3.1 Mount thermostat box 3.2 Install shuttle actuator and bracket SHUTTLE ➌ ACTUATOR ➋ ➊ THERMOSTAT GROMMET ➍ DOUBLE-SIDED TAPE THERMOSTAT BRACKET ➋ ➎ NUT §§ Apply double-sided tape to bottom of thermostat box and mount box on bin. §§ Install thermostat grommet ➊. §§ Remove protective tape and apply gaskets ➋ to shuttle actuator and nut. §§ Place shuttle actuator in hole ➌. §§ Install thermostat bracket ➍ and nut ➎.
4. Mount Ice Machine Mounting options: Wall bracket or Floor stand Wall bracket Floor stand ➋ 18.125" (46.0 cm) 26.25" (66.7 cm) 20.125" (51.1 cm) 6.80" (17.27 cm) ➊ B A C D A - 15.125" (38.4 cm), C - 13.25" (33.6 cm) B - 18.625" (47.3 cm) D - 20.75" (52.7 cm) Front View - Air Cooled 5. External Connections 5.1 Air-cooled ice machines only 5.2 Water-cooled ice machines only CONDENSER OUTLET ➋ ➌ ➍ ➋ ➊ ➊ §§ Install drain line ➊ (3/4” MPT).
5.3 Bin thermostat cable ICE MACHINE ➋ ➊ THERMOSTAT BOX ON BIN Note: Do not apply power to ice machine bin signal connection! Ice machine can only see contact closure. §§ Connect 2-pin bin thermostat cable at thermostat box on bin and at front of ice machine.
6. Transport tube installation Incorrect ice transport tube installation can result in wet ice and dispensing problems. Follow guidelines below to ensure correct installation. Call factory for assistance if you are unable to meet these requirements. 6.1 General requirements §§ §§ §§ §§ §§ §§ Maximum length of tube run – 20 ft (6 m). Factory approval required for longer runs. Run tube without dips. One continuous length of tube; no splices. Minimum radius of bends in tube – 6" (15.3 cm) inside radius.
7. RIDE model ice machine start up procedure The start-up procedure below is intended to ensure that ice machine is operating properly after installation has been made. Check each item listed and call factory immediately for assistance if you experience problems with unit. NOTICE! §§ Ice machine MUST be sanitized prior to operation! §§ Consult Operation and Service Manual provided with ice machine for sanitizing instructions. 7.1 Before turning on power 1. Turn on water to ice machine. 2.
Bin • RIDE Technology Maestro Plus 11
Maestro Plus and Harmony are trademarks of Follett LLC. Follett, Chewblet and RIDE are registered trademarks of Follett LLC, registered in the US. 801 Church Lane • Easton, PA 18040, USA Toll free (877) 612-5086 • +1 (610) 252-7301 www.follettice.