Owners Manual

Specications

Electrical

Each ice machine and dispenser require a separate circuit with electrical disconnect within 10 ft (6 m). Equipment

ground required. Standard electrical – 115V, 60Hz, 1 phase. Maximum dispenser fuse – 15 amps. For ice machine

circuit requirements, refer to the ice machine specication sheet.

Model Dispenser

number amperage

VU155M series 2.4 amps

(no integral beverage cooling)

VU155B series 4.4 amps

(integral beverage cooling)

Plumbing

Dispenser 3/4" PVC pipe nipple for bin drain

3/4" PVC pipe nipple for drain pan drain

1" ID hose for beverage bath drain

Beverage connections

1/4" ID syrup beverage hose

3/8" ID carbonated water beverage hose

3/8" ID plain water beverage hose

Note: Drains should be hard piped and insulated. Maintain at least 1/4" per foot (6 mm per 304 mm run)

slope on drain line run.

Water disconnect within 10 feet (3 m) of dispenser is suggested for automatic load units.

Follett recommends use of a Follett water lter system (part# 00130229) on ice machines

connected to automatic ll dispensers.

Ice machine Refer to detailed specications in ice machine installation manual packed with ice machine