Owners Manual

Field wiring diagrams
Note: Field wiring diagrams are intended to aid electricians or technicians in understanding how equipment
works. All eld wiring must be installed in accordance with all local and NEC codes.
DISPENSER
LEFT JUNCTION BOX
RIGHT JUNCTION BOX
BL
Y
RD
CONVERTER BOX
TO ICE MACHINE 2
CONVERTER BOX
TO ICE MACHINE 1
Electric
Power
Source
GND
GRN
B
W
Installing optional auto-ll ice machine kit(s)
Correct installation of RIDE
™
model ice machines is critical to proper performance of ice machine. Refer to
installation manual packed with ice machine for important details on ice transport tube run, ventilation
requirements and other installation requirements. Failure to comply with instructions may void warranty.
To start and operate dispenser
1. Follow detailed cleaning instructions in service manual before operating dispenser.
2. On units with Follett integral ice water bath beverage cooling (“B” models) only, slowly pour water into ice
water bath area to ll empty bath and submerge coils. Coils are submerged when water starts to ow out
overow drain. DO NOT SPLASH WATER ON ELECTRICAL BOX. Once lled with water, add ice to bath
until ice covers top of water bath.
3. For manual load units, remove front drain pan or rear lid and ll storage area with approved ice.
Note: Follett manual load dispensers can accommodate most cube/cubelet ices up to 1" square, or Follett
compressed nugget ice. Crushed, ake, bagged, nugget or congealed ice cannot be used. Use of these
ices can jam dispenser and void warranty. Separate any “waffle-like” sections of cubes before adding to
dispenser. For ice compatibility questions, please call Follett customer service at [phone]
or [phone].
4. Turn power switch located on dispenser control box to ON position.
5. For automatic ll units, follow detailed instructions in ice machine installation section of installation manual,
then turn ice machine (bin signal) switch(es) located on dispenser control box to ON position and begin to
make ice.
6. When dispenser has at least 6" (153 mm) of ice in storage area, test operation.
7