Owners Manual
Installing optional auto-ll ice machine kit(s)
Correct installation of RIDE
™
model ice machine(s) is critical to proper performance of ice machine. Refer
to installation manual packed with ice machine for important details on ice transport tube run, ventilation
requirements and other installation requirements. Failure to comply with instructions may void warranty.
To start and operate dispenser
1. Follow detailed cleaning instructions in service manual before operating dispenser.
2. On units with Follett integral ice water bath beverage cooling (“B” models) only, slowly pour water into ice
water bath area to ll empty bath and submerge coils. Coils are submerged when water starts to ow out
overow drain. DO NOT SPLASH WATER ON ELECTRICAL BOX. Once lled with water, add ice to bath
until ice covers top of water bath.
3. For manual load units, remove front drain pan or rear lid and ll storage area with approved ice.
Note: Follett manual load dispensers can accommodate most cube/cubelet ices up to 1" square, or Follett
compressed nugget ice. Crushed, ake, bagged, nugget or congealed ice cannot be used. Use of these
ices can jam dispenser and void warranty. Separate any “waffle-like” sections of cubes before adding to
dispenser. For ice compatibility questions, please call Follett customer service at (877) 612-5806 or
+1 (610) 252-7301.
4. Turn power switch located on dispenser control box to ON position.
5. For automatic ll units, follow detailed instructions in ice machine installation section of installation manual,
then turn ice machine (bin signal) switch(es) located on dispenser control box to ON position and begin to
make ice.
6. When dispenser has at least 6" (153mm) of ice in storage area, test operation.
11