User Manual

3. Parameter Setting and Query

3.1 PTZ Setup

E.g. With address code 28, steps to change to Pelco-P protocol and baud rate to 9600 are as follows:

Press【SETUP】button for 3 seconds under normal working mode, it displays as follows:

Then press 【ENTER】,there will be a 1sec beep sound when setting done.

Press【ESC】 3 times to back to normal working mode.

Note: Steps to set all devices to be with same protocol and baud rate are as follows:

Enter into the setup page and choose the corresponding protocol and

baud rate. Then all devices within 0-255 addresses are set with the same protocol and baud rate.

3.2 System Setup

System setup includes: password setting, Restore factory setting, Indicate sound switch setting,

Keyboard ID and Keyboard lock switch setting.

Here shows the steps to restore factory setting and set keyboard lock switch.

3.2.1 Password Setting

Press【SETUP】button for 3 seconds under working mode, it displays as follows :

Then input the new password again，press【ENTER】，there will be a 1sec beep sound when setting

Enter password(default is 8888)

Press

【Enter】

Press【2】【8】

Press

【Enter】

Move joystick downward to

choose the right protocol

Move joystick rightward to choose

the right baudrate

Move joystick downward

press 【Enter】

press 【Enter】to enter original password, press

【Enter】to input new password(4 digits)

input password to【Enter】