User Manual

6
6
done. Press【ESC】twice to back to normal working mode.
3.2.2 Restore Factory Setting
Press【SETUP】button for 3 seconds under working mode, it displays as follows :
Press 【ENTER】,there will be a 1sec beep sound when setting done.
Press 【ESC】 twice to back to normal working mode.
3.3 Keyboard Parameter Setting Frame
>PTZ Setup
Camera address： XXX（to
be set）
PROTPCOL
PELCOD,PELCOP,RULE,ctc
Baud Rate
2400,4800,9600,19200
Camera address：0-255（all
set the same）
Same as above
>SYSTEM Setup
>SET PASSWORD
OLD PW：old password
4 digits
NEW PW(new password）
4 digits
AGAIN PW:(confirm
password）
4 digits
>LOAD DEFAU
(restore factory setting）
confirm？
Press 【ENTER】to
confirm ,and【ESC】to exit.
>SYSTEM Setup
>SOUND SETUP (button
sound switch setting）
ON
Move joystick right/left and
press【ENTER】to confirm
OFF
>HOST ID SET
Keyboard address
Number【0】-【15】
>LEARN SETUP（keyboard
lock setting）
ON
Move joystick right/left and
press【ENTER】to confirm to
set password
OFF
3.4 keyboard parameter query
Protocol：X
Baud rate：X
current control protocol and baud rate.
Camera query
Camera protocol：001
protocol
Corresponding protocol
Baud rate
Corresponding baud rate
System query
Model number：
XXXXXXXX
Max 10 digits
Serial number：
XXXXXXXX
8 digits serial number on camera
Enter password
Move joystick downward
press 【Enter】
Move joystick downward
press
【Enter】