User Manual

17
8. RECEIVER INSTALLATION
8.1 Preparation For Installation
1. Required Tools:
(1) Flat Head Screwdriver (-)
(2) Phillips Head Screwdriver (+)
(3) Multi-Meter
(4) 14mm Wrench x 2
(5) 10.5mm Drill-Bit
2. Ensure receiver is not set to the same channel and ID code as any other units in
operation at the same facility.
3. Prior to installation, make sure the equipment itself is working properly.
4. Use the multi-meter to check the voltage source available and ensure receiver voltage
setting is correct for this voltage.
5. Prior to installation, switch “off” the main power source to the equipment.
8.2 Step By Step Installation
1. The location selected should have the antenna visible from all areas where the
transmitter is to be used.
2. The location selected should not be exposed to high levels of electrical noise.
3. Ensure the selected location has adequate space to accommodate the receiver
enclosure.
4. Make sure the receiver unit is in upright position (vertical).
5. The distance between the antenna and the control panel should be as far apart as
possible (see diagram next page).
6. Drill a hole on the control panel (10.5mm)
7. Tightened the two bolt nuts provided.
8. If the control panel has a plastic surface, extended grounding wire should be used.
9. For system wiring, please refer to the output contact diagram on page 12~14 or on the
receiver enclosure.
10. Ensure all wiring is correct and safely secured and all screws are fastened.