User Manual

20
5. In case of an emergency, press down the red EMS pushbutton will immediately deactivates
the receiver MAIN. When the EMS pushbutton is activated, the status LED on the
transmitter unit will display a red blinking light to indicate EMS activation (ON  0.5
second and OFF  0.5 second). To reactivate the system again, turn the EMS pushbutton
clockwise so that the red cap will elevate to its non-active position. Then turn the
transmitter power switch “off” and then “on” again to activate all transmitte r key functions
and the receiver MAIN. As for the Alpha 540T and 560T models, to reactivate the system
after EMS reset, just press any command pushbutton (please refer to JP1 setting on page 15
and 16).
6. Please note that conflicted movements are inte rlocked to one another for safety purpose.
Pressing conflicted commands at the same time will result in a non-transmission.
LED DI SPLAY