User's Manual

- 13 -
F
U
S
E
JP1
OPEN→JUMP
SHORT→JUMP
AC
DIP-SW
U
JP3
JP2
JP4
7.3 Receiver Function Setting
7.3.1 Set by programming tool
7.3.2 Adjust Jumper setting function by decoder board
α608 function can be changed simply by adjusting Jumper setting. Please refer to Jumper Set Table as
below.
Receiver function setting:
A. Select any pushbutton or ON/OFF power switch to start the system. The MAIN relay will be activated
when system is started. (after the receiver power is started and emergency stop button is elevated)
B. The MAIN relay auto shutdown time can be set as 3 minutes or depends on customer’s single request.
(Remark 1)
C. When transmitter voltage is low, relays for the receiver MAIN and LV (Remark 1) will be auto
shutdown after one minute.
(Fig. 12) Alpha 607, 608 models
Jumper Set table: in-plant setting (default).
JP1 Open
Power key to activate relay MAIN relay (After turning
“on” the transmitter power and pressing the emergency
Stop button)
Open No auto shutdown time on Main relay
JP2
Short
The receiver MAIN will be deactivated after
consecutive 5 minutes of standby time.
Open No auto shutdown time on MAIN and LV relays
JP3
Short
After one minute of transmitter LV, the MAIN and LV
relays will be deactivated.
Open 7
th
AUX: “Normal” pushbutton setting
JP4
Short 7
th
AUX: “Togglel” pushbutton setting
※ Open → no Jumper Short → put Jumper
Remark 1：The setting of auto shutdown time can be done by manufacturer or distributor. Setting range: 0~30
minutes. (In-plant setting: 3 minutes)
Remark 2：When the transmitter voltage is low, LV relay will be activated and siren or lights will be ON. (one
second of interval)