Parts List

- 32 -
7.5 Receiver Function Settings
7.5.1 α604/607/608 Receiver Function Settings
7.5.1.1 Set by the programming tool
Set from programming port CN5.
7.5.1.2. Adjust the jumper setting function on the decoder board
Adjusting the jumper setting to change the function selection (refer to Jump Set table as below):
* α600XJ series is for Mode 1 only.
JP1：Insert short pin onα604/607/608. For power switch startup only.
JP2： No function.
JP3：“ JP3 (一)“＿For α604AJ/BJ,607AJ/ATJ/BJ/BTJ and 608AJ/BJ.
“ JP3(二) α608T only”＿For α608ATJ/BTJ.
FUSE
JP1
OPEN→JUMP
SHORT→JUMP
AC
DIP-SW
U
JP3
JP2
JP4
Jumper Set table: in-plant setting (default).
JP1
Open
Not available
Short
Transmitter power switch start (when MAIN is off)
JP2
Open
No function
Short
No function
JP3(*1)
Open
When the transmitter voltage is low, LV relay
activates/deactivates every second.
Short
* 4 pushbuttons: When either relay of pushbutton 1~4 is
activated, LV relay will also be activated.
* 8 pushbuttons: When either relay of pushbutton 1~6 is
activated, LV relay will also be activated.
* 12 pushbuttons: When either relay of pushbutton 1~8 is
activated, LV relay will also be activated.
JP3(*2)
α608T only
Open
MAIN relay off, I & II relays remain unchanged
Short
MAIN relay off, I & II relay off.
JP4
Open
7
th
AUX pushbutton: Set as “Normal”
Short
7
th
AUX pushbutton: Set as “Toggle”
“Start” means: MAIN relay unlatches and then latches.
※ Open → no Jumper Short → put Jumper