User Manual

3
2
2
.
.
S
S
A
A
F
F
E
E
T
T
Y
Y
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
The Twister 2X system is relatively simple to use. However, it is very important to observe
the proper safety procedures during ope ration. When use properly the Twister 2X systems
will enhance productivity and efficiency in the workplace.
The following instructions should be strictly followed:
1. Make a daily check of the transmitter casing, joysticks, and pushbuttons. Should it
appear that anything could inhibit the proper operation of the transmitter unit, it should
be immediately removed from service.
2. The transmitter voltage should be checked on a daily basis. If the voltage is low, the
battery pack should be recharged or replaced.
3. The emergency stop pushbutton (EMS) should be checked at the beginning of each shift
to ensure they are in the proper working order.
4. In the event of an emergency, activate the emergency stop pushbutton immediately.
Then turned the power “off” from the main power source of the equipment.
5. The power switch should be turned “off” after use and should never left the power “on”
when the unit is unattended.
6. Do not use the same RF channel and ID code as any other unit in use at the sa me
facility (within 300-meter range / 900 feet).
7. Ensure the waist belt is worn at all time during operation to avoid accidental dropping.
8. Never operate a crane or equipment with two (2) transmitter units at the same time with
same RF channel and ID code.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operations.
Changes or Modifications not expressly approved by the party responsible
for compliance could void the users’ authority to operate the device.