Installation Guide

Sink Drain
With Removeable Strainer
Installation Instructions
１
２
1. Remove the filter from the drainer,
and then crew out the ferrule with
a screwdriver to separate the filter
flange from the drainer body.
2. Place the filter flange into the sink,
making sure the thin rubber gasket
is in place.
3. Lubricate flange gasket with water,
place into lip of drain body and
position drain body on the sink bottom.
Installation
4. Align the ribs on the drain body and
filter flange, then screw in ferrule
and tighten with a screwdriver.
Caution: Do not over tighten.
• Maximum diameter of drain flange: 4-13/32"
• Specification for drain nut:
2" (minimum thread diameter about 2-1/4")
1.5" (minimum thread diameter about 1-3/4")
5. Push strainer into ferrule in
drain body.
6. Make sure washer is in position,
slide nut on 2" drain tubing and
hand tighten the drain body nut.
Test for leaks.
Thin rubber gasket
Strainer flange
Sink
Flange gasket
Drain body
Sink
Ferrule
Sink
Strainer
Sink
Strainer
Drainer
Sink
Washer and
Nut and
Drain tubing
(Not supplied)