USER MANUAL Fontanella AQUA | S PARKLING | C A F É
GENERAL ADVICE It is important this manual is retained with the appliance for future reference. If the appliance is sold or transferred to another party, make sure this booklet is delivered to the new user, so they are made aware of the operation of the machine and its warnings. Before using the equipment read this manual carefully. Knowledge of the information and requirements contained in this manual is essential for proper installation and proper use of the appliance by the user.
Fontanella is NOT a toy. Keep out of reach of children. Close supervision is necessary when Fontanella is used near children. Electrical Hazards Only connect Fontanella to a power outlet with a grounding system. The voltage must correspond to the value indicated in the technical data section. If the supplied power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a hazard.
Sparkling Function Precautions Caution: Please DO NOT expose the Sparkling Plastic Bottle to temperatures above 49°C (120°F) or below 1 °C (34 °F). Caution: Please DO NOT wash the Sparkling Plastic Bottle in the dishwasher. Rinse in hot water. Please DO NOT place the Sparkling Plastic Bottle in the freezer. Doing so will compromise the integrity of the Sparkling Plastic Bottle material and may result in serious personal injury.
TECHNICAL DATA Voltage : Power : Protection Class : Operating Temperature : 220 ~ 240 V – 50 Hz 1,250 - 1,600 Watts I 10 - 45 °C (50 - 104 °F) DECLARATION OF CONFORMITY Fontanella complies with the following standards: For parts that come into contact with food substances, it complies with the prescription of the EEC directive 89/109 and of the Law by Decree n.
INTENDED USE Disposal of Packing Remove any protective sticker, paper, and plastic bag from Fontanella. All materials are compatible with the environment and can be recycled. We would like to ask you to contribute the environment protection by using the proper channels for the correct waste disposal. Getting Started Moisture may be kept inside the water tank or surface due to the mechanism test performed by factory as to ensure proper functioning. Please remove by a damp cloth.
b) Remove this plug by gently pulling. c) Fill the ICE Bank through the hole with 900mL of water using the Syringe provided (requires 18 times filling). d) Place the plug back in to the hole at the top of the ICE Bank. Caution: Please DO NOT inject more than 900mL of tap water into the ICE Bank. Overflowing the ICE BANK will cause damage to Fontanella. 3. Fill the Water Tank Fill in the Water Tank with maximum 3 litres of the tap water (room temperature). Please do not exceed the MAX line marked.
Water Treatment With Fontanella, the water is filtered and delivered Still Ambient, Cold, Sparkling or Hot. Caution: Fontanella is designed to use only drinkable water coming from municipal water supply. The manufacturer declines any responsibility in case of non-drinkable water or of water not controlled by the water authority. Any warranty will be deemed void in this case.
Standby Mode The Fontanella will go into Standby Mode (also referred as Sleep Mode) when Fontanella is idle for more than 28 minutes. This mode helps conserve and save power when Fontanella is not in use. To restart, hold down the Push Button of the Control Scroll for several seconds, and the Fontanella will again be ready for use (Note: It is not necessary to start Fontanella by pressing the ON/OFF Button).
Water or Coffee Selection The built-in system has 4 possible selections as seen below, with programmable doses (see paragraph “User Programming”): To select and activate, turn the Control Scroll until you reach the desired icon of the desired beverage and press the Push Button once, located over the Control Scroll. Note: Please press the Push Button continuously for Hot Water supply.
pensing the selected beverage. Release the Push Button once you reach the desired quantity and the dose will be set. Cold Water Temperature Adjustment The Thermostat Cooling Controller, located in the left side panel at the top next to the CO2 Canister, regulates the temperature of the water. To make the water cooler, turn the Thermostat Cooling Controller clockwise.
Brewing Unit pre-heating. This will happen when the hot water inside the Coffee Brewing Unit has not reached its requested temperature: this normally takes approximately 20 seconds. When the pre-heating progress is complete, the Coffee lcon Light will stop flashing and the Fontanella is ready to make coffee. Caution: Please DO NOT pull out the Coffee Capsule Holder when coffee is brewing. DO NOT touch Coffee Spout whilst making coffee. Caution: Please DO NOT use the same Coffee Capsule more than once.
Caution: Please DO NOT insert any Coffee Capsule that is broken or pierced, or any used Coffee Capsule or into Fontanella, otherwise it may jam inside the coffee brewing system, causing damage to the Fontanella. Tip: Before inserting a new Coffee Capsule, press the Push Button (on coffee setting) and dispense and discard one dose (whether there is an existing used Coffee Capsule in place or not). This will ensure your first and subsequent coffees are optimal.
occur. This indicates the Sparkling Plastic Bottle is damaged. DO NOT use the Sparkling Plastic Bottles that are scratched, worn, discoloured, or damaged in anyway. Caution: Please DO NOT carbonate any liquids other than plain water. You can only add flavour after carbonation is done. Caution: Please DO NOT press or hold the Sparkling Button for too long. Note: Suggested amount of sparkling is 3 presses of approximately 2 seconds each. To increase the amount of sparkling, do extra presses.
Trouble Shooting If there is no water coming out from the Fontanella, please check the Control Box, make sure that the Water Source Selection Switch is turned down to “Water Tank” position. Therefore, Fontanella will input water from the “Water Tank.” If the Cold Water is not cooling adequately, check the Thermostat Cooling Controller located in the left side panel and follow instructions as outlined above (under “Cold Water Temperature Adjustment”).
“Fontanella” CWM-01 12 Months Warranty Card Thank you for selection the Fontanella CWM-01. Fontanella provides a 12 month replacement warranty covering defects in materials or workmanship from the date of product purchase (in Australian market only). Equipment deemed to be defective in parts or workmanship will be repaired or replaced at the discretion of Novalink Holding Pty Ltd.
