Use and Care Guide

10
Marmoleum® Click Cinch Loc has a strong, durable protective top layer – Top-
shield™2. This innovation from Forbo ensures a highly e ective shield against
dirt and scu marks. Marmoleum® with Topshield™2 is ready for use immedi-
ately following installation and does not require the application of additional
protective coats of  nish. With Topshield™2, your Marmoleum®  oor will main-
tain its beautiful appearance with simple cleaning. Dry dusting is a fast and
easy way to keep your  oor free from loose dirt. Remove spots with a mop or
cloth dampened with diluted Forbo Neutral pH Cleaner. Avoid excessive use
of water on the  oor, and make sure chair and furniture
legs are covered with felt protectors. An entrance mat
will protect the  oor from dirt.
Initial Care Following Installation
1. Remove all surface soil, debris, sand and grit by sweeping, vacuuming or
dust mopping.
2. Mix 1/2 – 1 ounce of Forbo Neutral pH Cleaner per 1 gallon of unheated
tap water.
3. Apply the solution to the  oor. Do NOT  ood the  oor. The solution can
be applied with a mop and bucket.
4. Pick up soil and excess solution with a clean mop. Rinse mops frequently
and change the solution as needed.
5. Rinse the entire  oor surface with a clean mop using clean, cool water. Pick
up rinse water with a clean, dry mop or towel.
6. Allow the  oor to dry thoroughly before allowing tra c.
Routine Floor Care Procedures
1. Remove all surface soil, debris, sand and grit by sweeping, vacuuming or
dust mopping.
2. Mix 1/2 – 1 ounce of Forbo Neutral pH Cleaner per 1 gallon of unheated
tap water.
3. Apply the solution to the  oor. Do NOT  ood the  oor. The solution can
be applied with a mop and bucket.
4. For ingrained dirt, a non-abrasive scrubbing sponge may be required.
5. Pick up soil and excess solution with a clean mop. Rinse mops frequently
and change the solution as needed.
6. Rinse the entire  oor surface with a clean mop using clean, cool water.
Pick up rinse water with a clean, dry mop or towel.
7. Allow the  oor to dry thoroughly before allowing tra c.
Spots & Spills
The vast majority of spills can be cleaned o your Marmoleum® satisfactorily.
If there are spills or pet “accidents”:
1. Act quickly.
2. Scrape or blot as much as possible.
3. Mop the  oor with a solution of Forbo Neutral pH Cleaner.
4. Damp mop with clean water.
5. If necessary, repeat steps 3 and 4. If the stain persists, as it may with glue,
varnish, paint, ink, tar, cosmetics, shoe polish, some wines, co ee and
some other substances, you may need to allow the solution to sit or “dwell”
on the  oor for several minutes. Rub the stained area with a green nylon
kitchen pad then rinse the area with clean water. Repeat if necessary.
If the stain persists, contact Forbo Product Support & Education Services
before trying any other procedures.
For further information on restoration, please contact Forbo’s Product
Support & Education Services at [phone].
caring for your  oor
933858 barbados, 933872 volcanic ash