User Manual

Battery Installation and ESC Arming

Battery Selection

We recommend the Kinexsis

3200mAh 22.2v 6S 30C Li-Po battery

(KXSB0023) for high performance operation or Kinexsis 3200mAh 14.8v 4S

30C Li-Po battery (KXSB0018) for standard operation. Refer to the Optional

Parts List for other recommended batteries. If using a battery other than those

listed, the battery should be within the range of capacity, dimensions and

weight of the Kinexsis Li-Po battery packs to ﬁ t in the fuselage. Be sure the

model balances at the recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. Apply the loop side (soft side) of the hook and loop tape (A) to the bottom of

your battery.

3. Carefully lift the back of the canopy hatch (B) to remove.

4. Install the fully charged battery (C) in the battery compartment as shown.

See the Adjusting the Center of Gravity instructions for more information.

5. Make sure the ﬂ ight battery is secured using the hook and loop strap (D).

6. Connect the battery to the ESC (the ESC is now armed).

7. Keep the aircraft immobile and away from wind or the system will

not initialize.

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver.

If the ESC sounds a continuous double beep after the ﬂ ight battery is

connected, recharge or replace the battery.

8. Reinstall the canopy hatch.

CAUTION: Always

keep hands away from

the propeller. When

armed, the motor will turn

the propeller in response

to any throttle movement.