Hub/Switch Configuration Guide

120 System Configuration Commands
shutdown all
Syntax
[no] shutdown all
Default
enabled
Mode
Global Config
Virtual LAN (VLAN) Commands
In SFTOS 2.4.1, the interface vlan command is the starting point for VLAN configuration.
Executing the command creates a new VLAN and invokes the Interface VLAN mode, where
all VLAN configuration commands reside for the specified VLAN. You execute this
interface vlan command (see interface vlan on page 123) from the Global Config mode.
Virtual LAN (VLAN) commands in this section are:
• clear vlan on page 121
• description on page 122
• encapsulation (VLAN) on page 123
• interface vlan on page 123
• makestatic on page 124
• mtu (VLAN) on page 125
• name (VLAN) on page 125
• network mgmt_vlan on page 126
Table 18 Commands in the Interface VLAN Mode
Commands
Command/Command Family
Description
Location of
Command Syntex Description
description
Add a description to the VLAN. This chapter
encapsulation
(VLAN)
Configure interface link layer
encapsulation type.
This chapter
exit
Leave the mode.
help
Display help for various special keys.
igmp
Configure IGMP Snooping parameters
for the VLAN.
IGMP Snooping Commands on
page 235
ip
Configure IP parameters.
makestatic
Change the VLAN type from Dynamic to
Static.
This chapter
mtu (VLAN)
Set the default MTU size. This chapter
name (VLAN)
Configure an optional VLAN name. This chapter
protocol
Configure the protocols associated with
particular group IDs.
This chapter
tagged/
untagged
Configure tagging for a specific VLAN
port.
This chapter