Hub/Switch Configuration Guide

146 System Configuration Commands
write
write
The functionality of this command is the same as for the copy system:running-config
nvram:startup-config
command, to save the running configuration to NVRAM, which
would be used while the system is re-booted the next time. The
write command defaults to
write memory.
Syntax
write memory
Mode
Privileged Exec
Configuration Scripting
Configuration scripting enables you to generate text-formatted script files representing the
current configuration. These configuration script files can be uploaded to a PC and edited,
downloaded to the system and applied to the system. Configuration scripts can be applied to
one or more switches with no/minor modifications.
Use the
show running-config command to capture the running configuration into a script.
Use the
copy command (See “copy” on page 139.) to transfer the configuration script to/from
the switch.
The commands in this section are:
• script apply on page 147
• script delete on page 147
• script list on page 147
• script show on page 148
• script validate on page 148
Related
Commands
copy
Uploads and downloads to/from the switch.
Note: The file extension must be “.scr”.
A maximum of ten scripts are allowed on the switch.
The combined size of all script files on the switch shall not exceed 500 KB.
Configuration script files are not distributed across the stack, and only live in the unit
that is the master unit at the time of the file download.