Hub/Switch Configuration Guide

36 Quick Start
Configuring the Management VLAN IP Address
To configure the management VLAN IP address, use the following commands:
For details on command syntax for the commands listed above, see General System
Management and Information Commands on page 55.
Configuring the Ethernet Management Port
To configure the IP address of the Ethernet Management port, use the following commands:
Command Syntax Command Mode Purpose
show interface
managementethernet
Privileged Exec Displays the Network Configurations
IP Address: IP Address of the interface. Default IP is 0.0.0.0
Subnet Mask: IP Subnet Mask for the interface. Default is 0.0.0.0
Default Gateway: The default Gateway for this interface. Default
value is 0.0.0.0
Burned in MAC Address: The Burned in MAC Address used for
in-band connectivity
Locally Administered MAC Address: Can be configured to allow a
locally administered MAC address
MAC Address Type: Specifies which MAC address should be used
for in-band connectivity
Network Configurations Protocol Current: Indicates which network
protocol is being used. Default is none.
Management VLAN Id - Specifies VLAN id
Web Mode: Indicates whether HTTP/Web is enabled.
Java Mode: Indicates whether java mode is enabled.
interface
managementethernet
Global Config
Invokes the (Config-if-ma)# prompt, at which you can execute the
ip
address
command.
ip address ipaddr
netmask
Interface Config Configure the management IP address and subnet mask:
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
management route
default
gateway
Global Config Set the default gateway.
Gateway Address range from 0.0.0.0 to 255.255.255.255
Command Syntax Command Mode Purpose
serviceport protocol
{none | bootp | dhcp}
Global Config Specify the network configuration protocol to be used (Bootp or
DHCP) for configuring access to the Ethernet Management port.
Alternatively, leave the default at
none and then manually configure
the IP information.
serviceport ip ipaddr
netmask
[gateway]
Global Config Manually configure the IP address, IP subnet mask, and default IP
gateway of the Ethernet Management port (service port).
show serviceport
Privileged Exec Verify the Ethernet Management port configuration.