Hub/Switch Configuration Guide

64 System Management Commands
serviceport protocol
Related
Commands
serviceport protocol
This command specifies the network configuration protocol to be used for configuring access
to the Ethernet Management port.
Syntax
serviceport protocol {none | bootp | dhcp}
If you modify this value, the change is effective immediately.
Use the
bootp keyword to require the switch to periodically send requests to a Bootstrap
Protocol (BootP) server for an IP address for the port, or use
dhcp to call a DHCP server
until a response is received. The
none keyword indicates that the Ethernet Management port
should be manually configured with IP information.
Default
none
Mode
Global Config
Command
History
show arp switch
This command displays connectivity between the switch and other devices. The Address
Resolution Protocol (ARP) cache identifies the MAC addresses of the IP stations
communicating with the switch.
Syntax
show arp switch
Mode
Privileged Exec
Usage
Report fields include:
serviceport protocol Set the network configuration protocol to be used for configuring access to
the Ethernet Management port.
show serviceport Display the IP configuration and MAC address of the Ethernet Management
port.
Version 2.4.1 Introduced.
Related
Commands
serviceport ip Set the IP, subnet mask, and IP gateway of the Ethernet Management port.
show serviceport Display the IP configuration and MAC address of the Ethernet Management port.