Hub/Switch Configuration Guide

show interface managementethernet
SFTOS Command Reference for the S2410, Version 2.4.1.0 75
show interface managementethernet
This command displays information about the management address of the switch.
Syntax
show interface managementethernet
Mode
Privileged Exec
Command
History
Usage
Information
The display parameters of the show interface command, when the keyword is
managementethernet, are as follows:
Version 2.3
Modified: Added the keyword
managementethernet to show interface to
provide the information that had been available through the
show network
command.
Table 9 Fields in Output of show interface managementethernet command
Field Description
IP Address The IP address of the interface. The factory default value is
0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value
is 0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default
value is 0.0.0.0
Burned In MAC Address The burned in MAC address used for in-band connectivity
Java Mode Enable or Disable. Specifies if the switch should allow access to
the Java applet in the header frame. Enabled means the applet
can be viewed. The factory default is disabled.
Locally Administered MAC Address If desired, a locally administered MAC address can be
configured for in-band connectivity. To take effect, 'MAC Address
Type' must be set to 'Locally Administered'. Enter the address as
twelve hexadecimal digits (6 bytes) with a colon between each
byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
should have the following mask 'xxxx xx10'. The MAC address
used by this bridge when it must be referred to in a unique
fashion. It is recommended that this be the numerically smallest
MAC address of all ports that belong to this bridge. However it is
only required to be unique. When concatenated with
dot1dStpPriority a unique BridgeIdentifier is formed which is
used in the Spanning Tree Protocol.
MAC Address Type Specifies which MAC address should be used for in-band
connectivity. The choices are the burned in or the Locally
Administered address. The factory default is to use the burned
in MAC address.
Management VLAN ID Specifies the management VLAN ID.
Network Configuration Protocol
Current
Indicates which network protocol is being used. The options are
bootp | dhcp | none.
Web Mode Enable or Disable