Operation Manual

LOADING COMPACT
DISCS
6000CD
Always check if the CD slot is empty
before inserting the CD.
6006CDC
To load a single CD:
•
Press and release the LOAD
button. ‘WAIT’ will appear in the
display.
•
You can optionally select which
position to load the CD by
pressing a preset button.
•
When the message changes to
‘LOAD CD’, and lights flash in the
CD entry slot, insert a CD into the
audio unit.
To load more than one CD:
•
Press and hold the LOAD button
until ‘LOAD ALL’ appears in the
display.
•
When this message changes to
‘LOAD CD’, and lights flash in the
CD entry slot, insert a single CD,
label side up, into the audio unit.
•
One of the disc icons will flash in
the display and the word ‘LOAD’
will appear. When the disc is
loaded, a number in one of the
disc icons will indicate its location.
•
The display will change to ‘WAIT’
and then the word ‘LOAD CD’ will
appear again. At this point, you
can load another CD.
•
Repeat the last step to load more
CDs or allow the unit to time out
if you have finished loading your
discs.
Note: You can only load six CDs. If
LOAD is pressed again, the display
will show ‘CDC FULL’.
Do not try to insert a CD into the unit
when ‘WAIT’ is displayed. Do not
insert two CDs in a figure of eight
fashion with edges overlapping.
WARNING
If the power to 6006 CDC units
has been disconnected, then
reconnected, the unit will
automatically check for the presence
of discs in the magazine. This will take
approximately 25 seconds. During
this time all functions except
Keycode entry will be locked out.
Sony CD
•
Insert a CD, label side up, into the
slot.
•
‘LOADING’, ‘READING CD’ and
‘AUDIO CD’ or ‘MP3 CD’ appears
in the display and playback starts
automatically.
25
Compact disc player