Installation Instructions
PARTS PART #
Undermount Clips
Mounting Kit - Undermount Sink
#T60048
A B
C
A
B
C
x4
x4
x4
Installation Instructions
Page 1/3
INSTALLATION PROCEDURE
A
1
Machine Screw
• Check the desired placement of the lavatory sink and allow space for
faucet and plumbing installation.
• Carefully position and trace the template on the countertop as directed
on the template. (Figure 1)
• Mark the faucet hole center line on the countertop in relation to the
center of the drain hole. (Figure 2)
D
D
Washer
E
Template
Threaded Knurl
E
x4
x1
• Note:It is recommended that cutouts in marble or stone countertops
be made by a professional.
*PLEASE NOTE IT IS HIGHLY RECOMMENDED THAT A LICENSED PLUMBER FULLY INSTALL THE SINK.
• Drill a ½ pilot hole on the inside of the outline and use a jig saw to
cut out the countertop opening.
© 2021 Foremost Groups, Inc.
2
• Using the template as a guide, mark the four hole locations for the
mounting hardware underneath the countertop.
• Using a
diamond bit, drill a ½ deep hole in each location.
• Clean the holes and apply quick set epoxy.
• Place one threaded knurl into each hole, and allow to cure for the
amount of time required according to the epoxy manufacturer’s
• Note: It is recommended this be done by a professional for marble
directions. (Figure 3)
and granite countertops
B
____
FIG 3
FIG 2
FIG 1
STEP-BY-STEP
ILLUSTRATED
RECTANGULAR UNDERMOUNT SINK
MODEL # 14-3207-W
SKU # 6070062