COVE BY PASS WIST Customer Service 1-888-620-3667 Please visit us on YouTube and view our COPY THE MODEL NUMBER FOR YOU RECORDS HERE # shower door installation videos. One may be available for your installation. READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted. @2015 Foremost Groups, Inc.
COVE BY-PASS PARTS LIST. FOR EMOS Customer Service 1-888-620-3667 DOOR PANEL TOP TRACK (1 pos) | BOTTOM TRACK (1 pes) | WALL JAMB (2 pos) (Snide Outdo) TOWEL BAR (2 pes) PANEL GUIDE (1 pcs) | BUMPER GUIDE (2 pos) | WALL BUMPER (Bros) | o & CLIP 1 61 ASS HANGER (4 pos) 238" TOWEL BAR WRENCH ROLLER (4 pcs) WALL PLUG (6 pcs) 11/2" SCREW (PCs) 3/8" SCREW (2 pes) (236" LONG poss) N\ WARNING: Safety glasses should always be worn SAFE SLIDER INSTALL ROD when working with tempered glass (4" LONG 1 pes) Recommended
COVE BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 1 Attach rollers to hanger clips on both panels. Rollers should be mounted so that the head of the mounting screw is on the same side of the panel as the screw head set into the hanger clip (see inset drawing). NOTE: The various holes in the hanger clip are used to fine tune the adjustment of the panel to make up for walls that are slightly out of square or plumb.
COVE BY-PASS FOREMOST STEP 2 . Customer Service 1-888-620-3667 Measure opening on bottom and cut STEP 3 Bottom track@ 1/8" shorter than opening. Place wall jamb down over bottom track so that the back of the jamb is between the bottom track and the wall. Using a level to insure jamb is plumb, mark hole locations. Remove jamb and drill holes about 1 1/2" deep at each of the marked locations. NOTE: When drilling into ceramic, glass or stone use a 1/4" MASONRY drill bit.
COVE BY-PASS STEP 8 Use 1 1/2" screws to anchor wall bumper and bumper guide into center hole on each side. FOREMOST Customer Service 1-888-620-3667 B> @3 11 screw STEP 8 STEP 9 ~ AN Measure opening at top of wall jamb, 4 cut Top track (1) 1/16" shorter than / o — opening. | \ ~ STEP 10 Place top track down over wall jambs as shown. SIDE VIEW STEP 11 Install outer Door panel by lifting up & into Top track (1) ( Do not lift by toque! bar, be careful not to bump panel against metal track.
COVE BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 12 Install inner door panel by lifting up & into Top track { Do not lift by towel bar ).
COVE BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 13 . Install Towel bars (3. "\ [—TOWEL BAR SCREW —L@ TOWEL BAR WRENCH s — CLEAR SLEEVE -CLEAR SLEEVE 1/8" DRILL BITS ~ 7 SIDE VIEW STEP 14 Position panel guide in center of Bottom track. Drill two 1/8" holes through screw holes in guide and into Bottom track. Position panels in guide as shown in inset drawing and attach guide to bottom track using 3/8" screws.
COVE BY-PASS STEP 15 At last, Install safe slider clip (9). TRIM SAFE SLIDER CLIP IF NECESSARY C ) SAFE SLIDER CLIP, SAFE SLIDER INSTALL ROD To install safe slider clip. Put install bar ] into clip and lift onto clip hanger pull down leaving clip in place. FOREMOST Customer Service 1-888-620-3667 CAULK ALL SIDES FINAL STEP: Caulk both sides of the shower door frame to seal. Keep the entire area dry for a minimum of 24 hours. Your installation is now complete. Thank you for choosing Foremost shower doors.