COVE FOREMOST Customer Service 1-888-620-3667 Please visit us on YouTube and view our shower door installation videos. One may be available for your installation. READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted. GORY THE MODEL NUMBER FOR YOU RECORDS HERE # Right Pivot Install Left Pivot Install @2014 Foremost Groups, Inc.
Customer Service-588-620-3667 PART LIST Pivot Jamb(1 Pos) Dewar Panel (1 Fes) Vinyl Swap (1 Pos) Thrashing (1 Pos) Strike Rail | \magnetic Strike (1 Pes) brm— Pivot Am Pivot Bushing (1 Pus) 114" Screw(d pes) 3/8" Crow (3 poa) Screw Cap (7 pos) Wall plug (8 pes} 112" Screw @ Pivot Plate @ pos) Pivot (z( Screw) | Wot sm: S| Machete Vi Sir Han die (1 pos) Wrench pos) Strikes Piece Vinyl Sweep (1 pos) Pivot Pitts Tiny! (1 pos) WARNING: Safety glasses should always be worn Recommended TOOLS when working with tem
COVE FRAME LESS PIVOT STEP 1 FOREMOST Customer Service 1-888-620-3667 Choose whether you will need to assemble your shower door to open from the right or left. STEP 2 Attach bottom Pivot Bracket Arm @ to Pivot Jamb Using 1 1/4" screws @ Insert Pivot Bushing @ into the hole in the pivot bracket. STEP 3 Attach top Pivot Bracket Arm @ to Pivot Jamb (Using 1 1/4" Screws @, Only put the screws in about 1/4 of the way.
COVE FRAME LESS PIVOT Follow the appropriate diagram below. Right Pivot Assembly Left Pivot Assembly ST STEP 9/ STEP STEP 11 step {lll © step 13 st Er 13O STERNE T~ [, step FOREMOST Customer Service 1-888-620-3667 STEP 9 Set glass door into place by placing the pivot pin that sticks out of the bottom pivot plate into the hole in the bottom Pivot Bracket Arm. Slide top Pivot Bracket Arm down over the top pivot pin and tighten down the screws to secures it in place.
COVE FRAME LESS PIVOT FOREMOST STEP 14 Set the Strike Adjustment Rail ® on the Threshold @ . Using a level to insure plumb, mark hole locations in the rail on the wall. Set rail aside and drill holes approximately 1 1/2" deep as marked and insert wall plugs. STEP 15 Put a small amount of silicone over sate hole, set Jamb Extender Piece @ against wall, set Strike Adjustment Rail ® against Extender Piece and attach to wall by running Screws @ through both pieces and into the holes you drilled.
COVE FRAME LESS PIVOT FOREMOST Customer Service 1-888-620-3667 FINAL ADJUSTMENTS Close the door and verify that the door closes flush to the magnetic strike jamb (6) from top to bottom. If the magnetic vinyl strip on the glass panel does not reach the strike jamb, you will have to remove the glass door panel and adjust the pivot pins attached to the top and bottom pivot plates. In the parts kit you will find a small Allen wrench that fits inside the pivot pins.
