Installation Guide

ManualsBrandsForemost ManualsKitchenCove 30.5 in. to max width of 32.5 in. x 72 in. H. Frameless Pivot Shower Door in Oil Rubbed Bronze with Clear Glass

COVE FRAMELESS PIVOT

Installation Manual

IMPORTANT: Record the Model No.(see carton) of your tub or shower enclosure for future reference.

Model No.

READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view.

The exploded view will also provide a helpful reference when relating to the location of the various parts and how

they are mounted.

C 2011 Foremost Groups,Inc.

6241 Northwind Parkway Hobart, Indiana 46342

1-888-620-3667

www.foremostshowerdoors.com

Summary of content (6 pages)

PAGE 1
COVE FRAMELESS PIVOT Installation Manual IMPORTANT: Record the Model No.(see carton) of your tub or shower enclosure for future reference. Model No. READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted. C 2011 Foremost Groups,Inc. 6241 Northwind Parkway Hobart, Indiana 46342 1-888-620-3667 www.foremostshowerdoors.
PAGE 2
17 9 15 14 10 7 11 8 13 12 13 12 20 13 12 16 1 18 10 13 12 5 11 13 12 13 12 2 6 14 22 15 21 8 3 PART LIST. 1 4 2 3 7 9 5 4 TOO LS.
PAGE 3
Step 1) Measure and cut threshold to your exact opening size. Step 2) Silicone or Caulk bottom of threshold. CAULK GLUE When attaching your door to Fiberglass orAcrylic you must use a 1/8" drill bit and NO WALL ANCHORS. Next: Step 1) Attach support pivots(#7 on parts list) to bottom of pivot jamb(#1 on parts list). Step 2) Set pivot jamb on the threshold. Step 3) Mark your holes, remove jamb Step 4) Drill holes and then attach pivot jamb.
PAGE 4
Step 5) Attach support pivot arm to top of pivot jamb, screw together, but do not tighten. Set glass door (#2) into the metal support pivot arm at top and bottom of door (pin at top of bracket). Step 6) Attach magnetic plastic to end of the door. Step 7) Attach plastic (#16) to back of the glass door.
PAGE 5
For the opposite side of the Unit! 5 20 Step 1) Line up wall jamb (#5) and mark holes. Step 2) Drill holes. Step 3) Insert wall plugs (optional) Do not use plugs if attaching to a fiberglass unit. Step 3a) Silicone holesStep 3b) Attach open wall jamb (#5) to the closed wall jamb (#20). Step 3c) Then screw them together in to the wall. Step 4) Attach magnetic jamb (#6) to the wall jamb (#5).
PAGE 6
PLEASE CLOSE THE PIVOT DOOR AND CHECK TO SEE IF THE DOOR IS CLOSE (FLUSH) TO THE MAGNET WALL JAMB(#6). IF THE MAGNETIC PLASTIC ON THE GLASS PANEL DOES NOT REACH THE WALL JAMB. YOU WILL HAVE TO REMOVE THE GLASS DOOR PANEL, AND READJUST THE PIVOT PIN THAT IS ATTACHED TO THE TOP AND BOTTOM OF THE BRACKET. (YOU SHOULD HAVE RECVIEVED A SMALL ALLEN WRENCH) THAT FITS INSIDE OF THE PIN AT THE TOP OF THE BRACKET.