Installation Instructions

2/5
5
Carefully remove pedestal sink from pedestal base and
install faucet and pop-up assembly as per the installation
instructions on pages 3 and 4.
7
Tighten lag screw (stud application) or toggle bolt (wall
application) until pedestal sink is snug against the wall.
Caution: Do not over tighten as this could break the
porcelain.
Please Note: Pedestal base should be supporting the
pedestal sink, since mounting lips are not designed to
hold the weight of the pedestal sink.
8
Apply a neat bead of bathroom silicone or caulking around
the edge of pedestal sink where the sink contacts the wall
and where the pedestal sink connects onto the pedestal
base. Check for leaks. (Figure 3)
9
Complete any final plumbing connections, such as the
lavatory supply kit, as per manufacturer’s instructions.
SINK
RUBBER WASHER
METAL WASHER
TOGGLE BOLT
BUTTERFLY
NUT
WALL
FIG 2A
STUD
LAG SCREW
FIG 2B
SINK
WALL
RUBBER WASHER
STEEL WASHER
CARE AND MAINTENANCE
Clean the surfaces with a non-abrasive cleaner and warm water. Dry with a soft cloth.
NOTE: IMPROPER CARE MAY CAUSE THE WARRANTY TO BECOME INVALID.
FIG 3
6
If instalIing directly onto the wall without a stud, use
toggle bolts. Push toggle bolts through the backside of
the pedestal sink. Place the pedestal sink on the pedestal
base. Place the complete unit into the desired position on
the wall at the same time pushing the toggle bolts
through the pre-drilled holes on the wall. (Figure 2A)
OR
If instalIing directly onto a stud, use lag screws. Place the
pedestal sink on the pedestal base. Then place the
complete unit in the desired position on the wall. Place
metal washer and rubber washer onto the lag screw (in
this direct order) and at the same time fastening the
pedestal sink directly onto the stud by screwing the lag
screw into the stud. (Figure 2B)