Marina Door and panel WIST Customer Service 1-888-620-3667 Please visit us on YouTube and view our shower door installation videos. One may be available for your installation. READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted.
Marina Door and panel PARTS LIST FOR EMOS Customer Service 1-888-620-3667 TRACK COVER TOP TRACK (1 pos) | BOTTOM TRACK (1 pos) v WALL JAMB (2 pcs) DOOR (1 pos) FIXED PANEL (1 pcs) | WEDGE VILELY (4 pes) VINYL (1 pos) MAGNETS oy T SEAL \SIC 1 u ds PLASTIC SWEEP(1 pes) MOUNTING BLOCKS(2 pos) HINGE(2 pcs) HANDLE (1 pos} WALL PLUG (11 pos) / ® SCREW 13/8" (11 pes) Recommended TOOLS WARNING: Safety glasses should always be worn when working with tempered glass 4mm 3mm UTILITY KNIFE WRENCH 144° SILICONE MEASURE T
Marina Door and panel STEP 1: Cut bottom track @ to exact size of the opening , Then set the bottom track in place and mark the hole locations. FOREMOST Customer Service 1-888-620-3667 STEP 2: Remove the bottom track and drill 3 holes about 1 1/2” deep at the previously marked locations. Note : When drilling into ceramic, glass or stone ,using a 1/4” Masonry drill bit ;When installing on fiberglass or acrylic using 1/8" drill bit and discard the wall plugs.
Marina Door and panel STEP 5: Place wall jamb into bottom track (2 using a level to insure jamb plumb ,Mark hole locations. FOREMOST Customer Service 1-888-620-3667 STEP 6: Remove Jamb and drill holes about 1 1/2 deep at each of marked locations . Note : When drilling into ceramic ,glass or stone ,using a 1/4” Masonry drill bit ;When installing on fiberglass or acrylic using 1/8" drill bit and discard the wall plugs.
Marina Door and panel STEP 9.1 Racetrack (1) factorize of the opening. 9.2 As shown ,slide the mounting blocks pinto top track (D , tighten mounting screw by Allen wrench . 9.3 As shown insert Hinge 3 into the top track . DO NOT TIGHTEN THE SCREWS PROVISIONALLY.. FOREMOST Customer Service 1-888-620-3667 STEP 10: Place Top track (1) down over wall jamb As shown mark the hole locations for mounting blocks. STEP 11: Remove top track and drill holes about 1 1/2 deep at each of marked locations .
Marina Door and panel FOREMOST Customer Service 1-888-620-3667 Choose whether you will need to assemble your shower door to open from the left or right . Follow the appropriate diagram below . Left Hand Assembly Right Hand Assembly STEP 13: As shown ,Run a thin bead of silicone caulk down the entire length of wall jamb and a half of bottom track which stayed on stationary panel side .
Marina Door and panel FOREMOST Customer Service 1-888-620-3667 STEP 15 15.1 As shown ,Run a thin bead of silicone caulk down the half of Top track (1) and place it down over wall jamb ,Attach to the wall by provided Screw . 15.2 Adjust the top hinge location and make sure there is a 22 1/8” wide space for the pivot door.
Marina Door and panel FOREMOST Customer Service 1-888-620-3667 STEP 17 17.1 As shown, Put the magnet plastic 40 on the wall jamb (4)and Attach magnetic door seal to door panel Install vinyl to opposite end of glass and plastic sweep ({9 on the bottom. 17.2 Install the handle on the door. STEP 18: Cut the wedge vinyl (7) to exact size of the fixed panel and insert them into the gaps of both sides of tracks .
Marina Door and panel FOREMOST Customer Service 1-888-620-3667 STEP 19: Close door and check to make sure the magnetic strip line up from the top to bottom necessary to adjust the both hinges locations ,then tighten all the screws and cover screws with provided caps. FINAL STEP: Caulk both sides of the shower door frame to seal. Keep the entire area dry for a minimum of 24 hours. Your installation is now complete. Thank you for choosing Foremost shower doors.