TIDES BY-PASS “:O:Q WIST Customer Service 1-888-620-3667 Please visit us on YouTube and view our shower door installation videos. One may be available for your installation. READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted. GORY THE MODEL NUMBER FOR YOU RECORDS HERE # @2014 Foremost Groups, Inc.
TIDES BY-PASS PARTS LIST.
TIDES BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 1 Attach rollers to flange at top of both panels. The outer panel has an offset lip on one side of the bottom frame. This lip is on the outside face of the panel and rollers should be mounted on the same side as the lip. The inner panel has holes drilled on one side only of the bottom frame. The holes are on the inside face of the panel and the rollers should be mounted on the same side as the holes.
TIDES BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 3 STEP 4 Measure opening on bottom and cut Place wall jamb down over bottom track so that the Bottom track @) 1 1/2" shorter than back of the jamb is between the bottom track and the opening. wall. Using a level to insure jamb is plumb, mark hole > locations. Remove jamb and drill holes about 1 1/2" deep at each of the marked locations. NOTE: When drilling into ceramic, glass or stone use a 1/4" MASONRY drill bit.
TIDES BY-PASS FOREMOST Customer Service 1-888-620-3667 e STET STEP 9 ] TN Run 1 1/2" screws through wall bumper @ 1 screw / -\ and then drive it into center hole on 4 | each side. ] STEP 10 // Measure opening at top of wall jamb, cut Top track @ 1/16" shorter than opening. STEP 11 Place Top track down over wall jambs as shown. ._0
TIDES BY-PASS FOREMOST Customer Service 1-888-620-3667 STEP 13 STEP 15 Install inner door panel by lifting up Hook lip of bottom guide into slot in bottom track and & into Top track. screw it to inside door bottom using 3/8" screws. -~ NOTE: This system works best if there is a small amount of play between the guide and panel. We suggest that you tighten the screws down completely and then back them off 1/4 turn. Slide the door panel from end to end of the track.