Instructions / Assembly

HAMMER
TAPE
MEASURER
MASONS
STRING
2” x 2”
WOOD
STAKES
SHOVEL
WHEEL
BARROW
DRILL
PHILLIPS
SCREWDRIVER
WOOD
BLOCKS
ADJUSTABLE
WRENCH
HANDHELD
SAW
POST HOLE
DIGGER
CONCRETE
Required Tools
STEP 1: PLAN YOUR DESIGN
Decide on your layout and remember to consider where the gate will be installed. Regular posts should
be set 72-1/2” apart, measuring from center to center of each post, while gate posts should be set 1“
wider than the width of the gate itself to allow room for the hinges.
Layout the perimeter of determined fencing area with stakes and masons string to keep posts in line
when installing. Place the wood stakes where you intend to install the posts.
Most ForgeRight aluminum panels can be installed on an incline. The same method of installaon should
be followed, simply push the panel up or down to accommodate a hill or slope.
Post Post
72-1/2”
Center of Post
PLEASE NOTE: Addional accessories are required if installing on hard surface, such as a deck, or if mounng the
end panel to a wall.
TIP: All aluminum panels can be cut to
the size needed. When cung, use a
standard hand saw or reciprocang saw
and be sure to leave 2” of spacing at the
end of each horizontal rail.
RECIPROCATING
SAW
Aluminum Fence Installaon Instrucons

Summary of content (3 pages)