Installation Guide

INSTALLATION INSTRUCTIONS

1. Bathroom Faucet

2. “O”-Ring

3. Rubber Gasket

4. Metal Gasket

5. Fastener

6. Hot and Cold Water Supply Hoses

7. Metal Pop Up Drain

8. Deck Plate (Vessel sink bathroom faucets do not contain

deck plates)

Included In the Package:

Before Installation:

• Turn off the water supply valves. Clean the mounting area

of the sink.

• Recommended width of mounting area is between

15cm-31cm (6”-12”) measured between centers of

outside mount holes.

• Diameter of mount holes must be 35mm (1.38”).

• Max countertop thickness is 35mm (1.38”)

• Water pressure Min 0.05MPa (7 psi) / Max 0.75MPa (109

psi)

• Water temp Min ≥ 20°C (68°F) / Max ≤ 85°C (185°F)

PAGE 1
2 INSTALLATION INSTRUCTIONS Included In the Package: 3 1. Bathroom Faucet 2. “O”-Ring 1 3. Rubber Gasket 4. Metal Gasket 5. Fastener 6. Hot and Cold Water Supply Hoses 7. Metal Pop Up Drain 8. Deck Plate (Vessel sink bathroom faucets do not contain deck plates) 4 5 Before Installation: • Turn off the water supply valves. Clean the mounting area of the sink. • Recommended width of mounting area is between 15cm-31cm (6”-12”) measured between centers of outside mount holes.
PAGE 2
Installation Steps: 1. Place the O-ring at the bottom of the faucet. 3. Pass the water inlet hose of the faucet through the sink hole and place the faucet standing on the sink. 6. Notice: Open the water valve at this time, to drain out the sewage in the water pipe for 15 seconds and then close it. 7. Screw the water inlet hose nut onto the water valve and tighten it with a wrench. Finally, open the water valve and enjoy your waterfall.