Installation Guide

Installation Steps:
Maintenance:
• Always operate the faucet gently to ensure years of use.
• To maintain the finish, always blot dry any water on the faucet
surface. Clean with a damp non-abrasive sponge and wipe dry
with a clean soft cloth.
• Although the finish is very durable, certain cleaners can damage
it. DO NOT use detergent powder, polishing powder, a nylon
brush, or anything that may scratch the finish.
• DO NOT use acidic cleaners on the faucet.
• If air temperature falls below freezing (0°C / 32°F), run the faucet
to prevent freezing.
• Shut off water supply valve when not in use for long periods.
• We reserve the right to make revisions to product design
without notice.
6. Notice: Open the water valve at this time,
to drain out the sewage in the water
pipe for 15 seconds and then close it.
7. Screw the water inlet hose nut onto the
water valve and tighten it with a wrench.
Finally, open the water valve and enjoy
your waterfall. (If your valve thread
doesn’t match, please contact the seller
to get the thread adapter.)
3. Pass the water inlet hose of
the faucet through the sink
hole and place the faucet
standing on the sink.
4. Put on rubber gasket and
metal gasket.
5. Put on the fastener and
tighten.
1. Place the O-ring at the
bottom of the faucet.
2. Run the deck plate through
the water inlet hose and place
it at the bottom of the faucet
body.
Note:
• The deck plate installation is
optional.
• Vessel Sink Bathroom Faucets
does not need to install the deck
plate.