Owner Manual

INSTALLATION INSTRUCTIONS

1. Faucet

2. Cold and hot water handles

3. Cold and hot water supply hoses

4. Black water hose with quick connectors

5. Rubber washer

6. Metal washer

7. Mounting nut

8. Mount screws

9. Pop-up sink drain stopper with mounting hardware

10. Gloves to protect finish from scratches during installation

11. Microfiber polishing cloth

2 2

Included In the Package:

Before Installation:

• Turn off the water supply valves. Clean the mounting area of

the sink.

• Recommended width of mounting area is between 15cm-31cm

(6”-12”) measured between centers of outside mount holes as

shown in the diagram.

• Diameter of mount holes must be between 32mm-35mm

(1.26”-1.38”) as shown in the diagram.

• Max countertop thickness is 35mm (1.38”)

• Water pressure Min 0.05MPa (7 psi) / Max 0.75MPa (109 psi)

• Water temp Min ≥ 20°C (68°F) / Max ≤ 85°C (185°F)

PAGE 1
4 INSTALLATION INSTRUCTIONS 1 5 6 7 2 2 3 9 8 Before Installation: Included In the Package: 1. Faucet 2. Cold and hot water handles 3. Cold and hot water supply hoses 4. Black water hose with quick connectors 5. Rubber washer 6. Metal washer 7. Mounting nut 8. Mount screws 9. Pop-up sink drain stopper with mounting hardware 10. Gloves to protect finish from scratches during installation 11. Microfiber polishing cloth • Turn off the water supply valves. Clean the mounting area of the sink.
PAGE 2
Installation Steps: 1. Feed hose through center mount hole and fit the faucet onto the sink. 5. Carefully screw the male ends of the cold and hot water supply hoses into the respective faucets (blue=cold, red=hot) and tighten firmly by hand. 10. Install the pop-up sink drain stopper. 2. Beneath the sink, slide the rubber washer, metal washer and mounting nut onto the threaded end of the faucet. 6.