Owner Manual

Installation Steps:
Maintenance:
9. Connect the hot and cold
water hoses to the water
supply valves. Secure the
connections with a wrench.
Open water supply valves
and check for leaks.
• Always operate the faucet gently to ensure years of
use.
• To maintain the finish, always blot dry any water on
the faucet surface. Clean with a damp non-abrasive
sponge and wipe dry with a clean soft cloth.
• Although the finish is very durable, certain cleaners
can damage it. DO NOT use detergent powder,
polishing powder, a nylon brush, or anything that
may scratch the finish.
• DO NOT use acidic cleaners on the faucet.
• If air temperature falls below freezing (0°C / 32°F),
run the faucet to prevent freezing.
• Shut off water supply valve when not in use for long
periods.
• We reserve the right to make revisions to product
design without notice.
10. Install the
pop-up sink
drain stopper.
7. Firmly connect the black
water hose to the handles by
attaching the quick
connectors to the brass
fittings extending from the
bottom of each handle.
8. Firmly connect the quick
connector in the middle of
the black water hose to the
short faucet hose. Check
that there are no kinks in the
hoses.
5. Carefully
screw the male
ends of the
cold and hot
water supply
hoses into the
respective
faucets
(blue=cold,
red=hot) and
tighten firmly
by hand.
Phillips
screwdriver
4. Insert the
two mount
screws onto the
mounting nut to
fix it in place,
again don’t
over-tighten.
3. Tighten the
mounting nut by
hand so that the
faucet is firmly
connected to
the sink, be
careful not to
over-tighten.
1. Feed hose through center
mount hole and fit the faucet
onto the sink.
2. Beneath the
sink, slide the
rubber washer,
metal washer
and mounting
nut onto the
threaded end of
the faucet.
6. Fit the handles
onto the sink using
the correct outside
mount holes and
apply steps #3-#5
above to secure
the handles.
Note: The black water hose must be installed
crosswise, as shown in the figure.