Technical Specifications

ManualsBrandsForm-A-Drain ManualsBuilding materials8" 90-Degree Corner

02621-1

SECTION 02621

FOUNDATION DRAINAGE PIPING

Display hidden notes to specifier. (Don't know how? Click Here)

PART 1 GENERAL

1.1 SECTION INCLUDES

A. Foundation Drainage System.

B. Perimeter Radon Gas Evacuation System.

1.2 RELATED SECTIONS

A. Section 02300 - Earthwork: Excavating for site subdrainage system piping,

surrounding filter aggregate and filter fabric.

B. Section 02630 - Storm Drainage: Connection to drainage system.

C. Section 03300 - Cast-In-Place Concrete: Concrete for foundations and footings.

D. Section _______ - _________________: Vertical Stack piping for radon vent.

1.3 REFERENCES

A. ASTM D 2729 - Standard Specification for Poly(Vinyl Chloride) (PVC) Sewer Pipe

and Fittings.

B. ASTM F 405 - Standard Specification for Corrugated Polyethylene (PE) Tubing and

Fittings.

C. ASTM F 891 - Standard Specification for Coextruded Poly(Vinyl Chloride) (PVC)

Plastic Pipe with a Cellular Core.

D. EPA 402R94009 - Model Standards and Techniques for Control of Radon in New

Buildings; Environmental Protection Agency.

1.4 DESIGN / PERFORMANCE REQUIREMENTS

A. Perimeter Radon Evacuation System: Provide products that can be assembled into

system that meets requirements of:

1. EPA 402R94009.

2. Provide test reports from independent testing laboratory supporting

compliance.

Summary of content (4 pages)

PAGE 1
SECTION 02621 FOUNDATION DRAINAGE PIPING Display hidden notes to specifier. (Don't know how? Click Here) PART 1 GENERAL 1.1 1.2 1.3 1.4 SECTION INCLUDES A. Foundation Drainage System. B. Perimeter Radon Gas Evacuation System. RELATED SECTIONS A. Section 02300 - Earthwork: Excavating for site subdrainage system piping, surrounding filter aggregate and filter fabric. B. Section 02630 - Storm Drainage: Connection to drainage system. C.
PAGE 2
1.5 1.6 SUBMITTALS A. Submit under provisions of Section 01300. B. [ Product Data ]: Manufacturer's data sheets on each product to be used, including: 1. Preparation instructions and recommendations. 2. Storage and handling requirements and recommendations. 3. Installation methods. C. Shop Drawings: Indicate layout of system; include all components specified in manufacturer's descriptive literature or installation instructions, and components indicated on the Drawings. D.
PAGE 3
5. 6. Type: Form-A-Drain Part LN128, size 2-1/4 inches (57 mm) wide by 8 inches (203 mm) deep, dual-channel. Type: Form-A-Drain Part LN1210, size 1-1/2 inches (38 mm) wide by 10 inches (254 mm) deep, dual-channel. B. Fittings: 1. Material: Extruded polyvinyl chloride (PVC) or molded polypropylene (PP) in profiles and shapes as follows: a. Coupling: Extruded PVC, Form-A-Drain Part XCPLx. b. Coupling with hole: Molded PP, Form-A-Drain Part COUPx. c.
PAGE 4
impede consistent backfilling or compaction. 3.3 3.4 INSTALLATION A. Install products in accordance with manufacturer's instructions. B. Lay out system to footing footprint indicated on Drawings; locate fittings in accordance with manufacturer's instructions and as indicated. C. Maintain indicated footing widths by installing spacer straps; locate in accordance with manufacturer's instructions and as indicated. D.