User's Manual

ManualsBrandsFormosa Teletek ManualsAudio EquipmentBLUETOOTH HEADSET

Bluetooth Headset

Bluetooth your safety

Rev. 1.1 (2004/7/29)

Introduction

This Wireless headset is base on Bluetooth technology, connects to a

compatible phone without wires. It is easily converting your mobile

phone communication to the headset. This headset integrated CSR

BC02 and LTCC technology, providing fast and reliable voice

transmission.

Note: This Bluetooth headset just supports “call receiving”

function, if Bluetooth phone only has headset profile,

without hands-free profile.

It doesn’t support a Bluetooth phone without headset

and hands-free profile, such as Nokia 7650.

The following page of this user manual focus on how to use this

product

olume up

olume down

Main button

LED

Microphone

Charger connector

Summary of content (8 pages)

PAGE 1
Bluetooth Headset Bluetooth your safety Rev. 1.1 (2004/7/29) Introduction This Wireless headset is base on Bluetooth technology, connects to a compatible phone without wires. It is easily converting your mobile phone communication to the headset. This headset integrated CSR BC02 and LTCC technology, providing fast and reliable voice transmission. Note: This Bluetooth headset just supports “call receiving” function, if Bluetooth phone only has headset profile, without hands-free profile.
PAGE 2
Getting started Charging the battery The headset has a rechargeable Lithium Polymer battery. You have 2 ways to charge the battery: 1. Charging by the AC charger a、 Connect the charger cable to the charger connector on headset b、 Connect the charger to an AC wall outlet. The red LED is on, during charge mode. It takes around 3.5 hours to fully charge the battery. The red LED is off when the battery is full. 2.
PAGE 3
Pairing You pair the headset with the phone by adding it to the pairing list in the phone. The two devices then recognize each other when they connect. 1. When the headset is off, press and hold the main button for 5 to 6 seconds until the blue/red LED fast flashes. 2. Prepare your phone for turning on Bluetooth function, searching new device, according to the phone user’s guide. Make sure the product is within 5m of the phone. 3. “Auto Blue” appears in the pairing list on your phone. Selects it.
PAGE 4
Making a call When the headset is connected to your phone, make a call by using your phone in the normal way. Making a voice dialing If your phone supports voice dialing, and it is activated, you can use this feature with this headset 1. Refer to the phone user guide to enable the voice commands on your phone; 2. On standby mode, press the main button. Wait for the tone that indicates you can say the name as you recorded on your phone.
PAGE 5
or PDA that is with Audio Gateway Profile supported. Please refer to the user manual of your Bluetooth enabled PC or PDA for a setup information. Important Information Trouble shooting 1. No indication of charging is shown. If the Headset battery that is empty or has not been used for a long time, it may take a couple minutes for the Headset indicator to show charging status with a steady red light. 2. If you cannot connect the Headset to your phone.
PAGE 6
- moisture can form inside, which may damage electronic circuit boards. Do not attempt to open the headset. Non-expert handling may damage it. Do not drop, knock or shake the headset. Rough handing can break internal circuit boards. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the headset. Do not paint the headset. Paint can clog the moving parts and prevent proper operation. Children Keep all accessories out if the reach of small children.
PAGE 7
establish a permanent security link between the devices and enable quick access to services provided without the need to enter passkeys. Bluetooth passkey Each headset has a default passkey 1234 for pairing, which is stored in its internal memory. You are usually required to enter the passkey 1234 in a pairing process with a Bluetooth mobile phone or other devices, however it depends on the kind of Bluetooth device that the headset is to connect to.
PAGE 8
NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.