User's Manual

Basic System Settings
For users who use KWG-O6020-I for the first time, it is recommended that you begin configuration
from “Basic Settings” in “System” shown below :
Figure 4
Basic System Settings
Basic Settings
Network Mode:
Specify the network mode, including Bridge and Router. It is easy to configure
parameters in Bridge Mode; however, users must pay extra attention to the way they configure the
device when it is set to Router Mode. For details, please refer to “IP Settings (Router)”.
Device Name
: Specify the device name for recognition, which is composed of no more than 15
characters with (0-9), (A-Z), (a-z) or (-). Device Name provides users with another option to view the
login webpage; in other words, open IE, enter the Device Name (ex: ap243943) of KWG-O6020-I into
the address field, click enter, and then login webpage will show up.
Country Region:
The availability of some specific channels and/or operational frequency bands is
country dependent.
Spanning Tree:
Spanning Tree Protocol (STP) is a link management protocol for AP which provides
path redundancy while preventing loops in a network. STP allows only one active path at a time
between the access points but establish the redundant link as a backup if the initial link fails.