User's Manual

Broadcast SSID
Under AP mode, hiding network name is necessary when you are in a wireless environment that may
have potential risk. By disabling broadcast SSID, the STA can not scan and find KWG-O6020-I, so that
malicious attack by some illegal STA could be avoided.
802.11 Mode
KWG-O6020-I can communicate with wireless devices of 802.11b/g or 802.11b/g/n. You can also
select Auto and make it work under an appropriate wireless mode automatically.
HT Protect
Enable HT (High Throughput) protect to ensure HT transmission with MAC mechanism. Under
802.11n mode, wireless client can be divided into HT STA and Non-HT STA, among which the one with
HT protect enabled gets higher throughput.
Channel Number
Channel varies much as the available band differs from country to country. Select a proper operating
channel in the drop-down list according to your situation.
Antenna
By default, KWG-O6020-I uses its built-in antenna for directional transmission; however, if you prefer
to use an external antenna for your case-dependent applications, you can switch from “ Internal ”
to ”External (N-Type)”.
!!!Note
z You are able to choose “External (N-Type)” only when you have well done installing the external
antenna; otherwise, it might hurt KWG-O6020-I itself.
Output Power
Specify the signal transmission power. The higher the output power is, the wider the signal can cover,
but the power consumption will be greater accordingly. Usually “Full” is preferred.
Data Rate
Usually “Auto” is preferred. Under this rate, KWG-O6020-I will automatically select the highest
available rate to transmit. In some cases, however, like where there is no great demand for speed, you
can have a relatively-low transmit rate for compromise of a long distance.