User's Manual

Chapter 5 Management
SNMP Management
KWG-O6020-I supports SNMP for convenient remote management. Open “SNMP Configuration” in
“Management” shown below. Set the SNMP parameters and obtain MIB file before remote
management.
Figure 21
SNMP Configuration
Enable SNMP
Check this box to enable SNMP settings.
Protocol Version
Select the SNMP version, and keep it identical on KWG-O6020-I and the SNMP manager.
Server Port
Change the server port for a service if needed; however you have to use the same port to use that
service for remote management.
Get Community
Specify the password for the incoming Get and GetNext requests from the management station. By
default, it is set to public and allows all requests.
Set Community
Specify the password for the incoming Set requests from the management station. By default, it is set