Instructions / Assembly

Table Screw Cap

FORMUFIT Inline Folding PVC Couplings connect two segments of PVC pipe externally,!and

folds over itself. To connect this product to PVC pipe, follow the instructions shown below.

Assembly

https://formuﬁt.com

PRODUCT INSTRUCTIONS

Position the Table Cap against a ﬂat surface.

Use the appropriate fasteners for the surface in

the tapered holes on the tabs.

Secure into place using a screwdriver, hammer

or power drill/driver.

Line up a segment of the same size PVC Pipe

and insert it into the socket of the Table Cap.

Insert the pipe into the Table Cap. PVC cement

will almost always be required for a secure

connection between Table Cap and Pipe.

PAGE 1
PRODUCT INSTRUCTIONS Table Screw Cap FORMUFIT Inline Folding PVC Couplings connect two segments of PVC pipe externally, and folds over itself. To connect this product to PVC pipe, follow the instructions shown below. Assembly 1 2 Position the Table Cap against a flat surface. Use the appropriate fasteners for the surface in the tapered holes on the tabs. Secure into place using a screwdriver, hammer or power drill/driver.
PAGE 2
Adjustment and Use The table cap can be secured using a large assortment of fasteners, such as screws (drywall, wood, masonry, etc.), nails or rivets. The fastener chosen must have a shaft diameter of no more than 0.20 in. (1/8”). Typically #10 size fasteners are the ideal solution for Table Caps of any size. Securing For permanent and strong connections, it is recommended to use PVC cement/solvent to attach the PVC pipe and the folding adapter.