Instructions / Assembly

Standard PVC Cross
FORMUFIT Standard PVC Cross Fittings can accept up to four (4) segment of PVC pipe and
can be used to create flat crossmember support. To connect this product to PVC pipe, follow
the instructions shown below.
Assembly
Securing
For permanent and strong connections, it is!recommended to use!PVC cement/solvent to
attach the PVC pipe and the PVC Cross fitting.
You can also temporarily connect this fitting by driving a self-tapping screw where the pipe
and fitting meet, or apply electrical tape over the end of the pipe before inserting into the
fitting for a temporary, yet strong connection.
All rights reserved. TM, ® & Copyright © 2009-2018 FORMUFIT LC
https://formufit.com
PRODUCT INSTRUCTIONS
Slip a segment of!PVC pipe inside one
of the sockets on the!Cross fitting.
Push or tap into place until the pipe
hits the stop inside of the socket.
Repeat for each additional socket.
1
2