Instructions / Assembly

ManualsBrandsForney ManualsOther120-Volt 20 Amp Easy Weld Plasma Cutter

QUICK START GUIDE

20 P PLASMA CUTTER

• Generator OK with continuous

output > 4,000 W

• Extension cord: #12 AWG or

larger; 25’ (8m) or shorter

120VAC, 20A

outlet, 30A breaker

recommended

Connect to Input Power

Travel speed Cutting capability Replace worn consumables

FIND MORE PLASMA CUTTING TIPS AT WWW.ASKFORNEY.COM

Drag tip on workpiece

OPERATING TIPS

Output air pressure is pre-set at the factory

Connect to input air

• 60-100 PSI

•

1.5 CFM

• Clean air

• No oil

• No moisture

Read user manual

QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038

customerservice@forneyind.com • askforney.com • forneyind.com

Will cut clean up to

1/4” (6.4 mm)

TROUBLESHOOTING GUIDE

Flashing green

Verify power source is

120 VAC +/- 10%

Low input power

Solid yellow

Allow machine to cool.

See manual.

Duty cycle exceeded

Flashing yellow

Ensure air input meets

pressure and flow

requirements.

Low input air pressure

Flashing red

Check consumable

assembly. Tighten cup. See

manual.

Consumables not in

place properly

NOTE: Correct consumable assembly

Torch body

Electrode

Air diffuser ring

Cutting tip (0.65)

Shield cup (two hole)

Too fast.Watch

spark trail angle.

CAT# 251

Replacement electrodes and cutting tips available in a 4-pack (2 ea.)

CAT# 85392

EN_v2-3

Summary of content (3 pages)

PAGE 1
CAT# 251 QUICK START GUIDE 20 P PLASMA CUTTER 1. Read user manual + 2. Connect to input air • 60-100 PSI • > 1.5 CFM • Clean air • No oil • No moisture Output air pressure is pre-set at the factory 3. 4. Connect to Input Power NOTE: Correct consumable assembly Drag tip on workpiece 120VAC, 20A outlet, 30A breaker recommended • Generator OK with continuous output > 4,000 W • Extension cord: #12 AWG or larger; 25’ (8m) or shorter a. Torch body b. Electrode c. Air diffuser ring d.
PAGE 2
CAT# 251 GUIDE DE DÉMARRAGE RAPIDE COUPEUSE AU PLASMA 20 P 1. Lire le guide de l'utilisation + 2. Connecter à l'air d’entrée • 60-100 PSI • > 1.5 CFM • Air propre • Absence d'huile • Absence d'humidité La pression de l'air de sortie est préréglée à l'usine 3. 4. Connecter à la puissance d’entrée REMARQUE : Assemblage correct des consommables Faites glisser la buse sur la pièce à souder Prise de 120 V en c.
PAGE 3
CAT# 251 GUÍA DE INICIO RÁPIDO MÁQUINA DE CORTE POR PLASMA 20 P 1. Lea el manual para el usuario + 2. Conecte al aire de entrada • 60-100 PSI • > 1.5 CFM • Aire limpio • Sin aceite • Sin humedad La presión de aire de salida viene configurada de fábrica 3. 4. Conecte a la entrada de energía Arrastre la punta sobre la pieza de trabajo NOTA: Corrija el ensamblaje de piezas consumibles 120 V CA, tomacorriente de 20 A, disyuntor de 30 A (recomendado) a. Cuerpo de la antorcha b.