Use and Care Manual
22
Operating Instructions (continued)
Care and Maintenance
Troubleshooting
pressing the UP or DOWN buttons (01-12), when done, press the CLOCK and repeat the steps for the minutes (00-59).
Other Function:
1. Press and hold on the UP or DOWN button can speed up the setting.
2. When proceed with sous vide function, simultaneously press the UP and DOWN buttons together can shift the
temperature between ºF and ºC.
3. Press and hold on the POWER button for 3 seconds to enter the child lock function, and hold on the POWER button
Attention
The sous vide cooking can not be worked together with the regular cooking mode. Any knob is turned on, the sous vide
function can not be used. The regular cooking also can not be used when the sous vide function is working.
Stainless steel
Use non-abrasive stainless steel cleaner, apply small amount to a soft cloth, slightly wipe the
stainless steel surface, then towel dry. When wiping on the stainless steel surface, always follow the
grain of the metal.
Control knobs
Using a damp cloth, wipe with a mild detergent or spray decreaser; rinse and dry. Do not put in
dishwasher for cleaning.
Oven interior
from oven cavity and window. For stubborn stains, spray with a mild abrasive cleaner or spray
decreaser. Clean the entire oven cavity with soap and water.
Oven racks
To clean the upper rack, use mild detergent and a scouring pad. Rinse and dry.
To clean the bottom pan, discard grease and wash with hot water and mild detergent. Rinse and
dry. The stainless steel rack is dishwasher safe. Do not place the porcelain-coated rack or pan in
dishwasher for cleaning.
Oven light
To replace the oven light bulb, unscrew the light cover inside the oven, replace the light with a 25-
watt halogen bulb.
Check troubleshooting before you call for service.
Issue Possible Cause Solution
Oven was not properly preheated.
Convection Bake and Convection Roast will eliminate any
moisture in oven (one of the advantages of convection).
Oven is not
heating.
No power going to the oven, Oven
Mode or temperature not selected.
Turn on power at the main power supply (fuse or circuit
electrician.
Oven is not
cooking evenly
Oven rack is not in correct position. Adjust the oven temperature setting, or move the oven
rack to the correct position.
Oven light is not
working properly.
Light bulb is loose or burned out.
seconds. Insert the light bulb tightly, or change the light
bulb directly.
Cooling fan
continues to run
after the oven is
The oven components have not
-
matically when the electronic components have cooled
Display shows Err1
Err2 Err3
Error Code for PCB board Err1: abnormal wire connection
Err2: Abnormal sensor signal for broiler
Err3: Abnormal sensor signal for oven