Installation Guide

19
Anti-Tip Bracket
To prevent the range from tipping forward, the anti-tip bracket must be installed.
Refer to the section of
ANTI-TIP DEVICE.
Gas Supply Connection
All connections to the gas piping must be wrench-tightened. Do not overtighten or allow pipes to turn when
tightening.
When all connections have been made, check that all range controls are in the “OFF” position and turn on the
main gas supply valve.
If a flexible metal connector is being used, verify it is not kinked, then attach the gas supply line to the regulator on
the range. Open the valve and check for leaks by placing a liquid detergent solution onto all gas connections.
Bubbles around connections indicate a gas leak. If a leak appears, close the shut-off valve and adjust
connections.
Leak testing of the appliance shall be conducted according to the manufacture’s instructions. Use some soap
water (50% water and 50% soap) or a leak detector at all joints and connections to check for leaks in the system.
Do not use a flame to check for gas leaks.
The appliance must be isolated from the building’s gas supply piping system by closing its individual manual
shut-off valve during any pressure testing of the gas supply piping system at test pressure equal to or less than
0.5 psi (3.5kPa).
DO NOT Forget Before Getting Started
• Remove the exterior and interior packing.
• Clean the range thoroughly with hot water and a mild detergent. Rinse and dry with a soft cloth to
remove any residual oil and grease left over from the manufacturing process.
• Check that surface burner components are assembled correctly.
• Furnish the interior of the oven by inserting the shelves and tray.
• The range mounted on its legs.
• Have the anti-tip device been properly installed.
• Ground the electricity properly.
• Connect the gas service line following the directions of the manufacturer.
• Check the gas connection for leaks.
• Make sure the range been set for the type of gas available in the household.
• Make sure the flame appear sharp blue, with no yellow tipping, shooting or flame lifting.
• Adjust the minimum setting for all burners.
Cooktop Operation
The burner assembly contains all accessories in one set. The burner cap must
be seated on the burner horizontally. Refer to the illustration.
Ignition
To light up the cooktop burners, push and turn the appropriate control knob counterclockwise to “Hi” position. You
will hear a clicking noise – the sound of ignition pin sparking.
Burner cap
Burner
igniter