Installation Guide

Once burner ignition has been achieved, turn the burner control knob to adjust to desired flame intensity.

If the knob stays at “HI”, it will continue to click.

NOTE: When one burner is turned to the “Hi” position, all the burners will spark. Do not attempt to disassemble

or clean around any burner while another burner is on. Do not touch any burner cap, burner base, or igniter while

the igniters are sparking.

Heat Settings:

Ignites the burners.

Simmer

Melting small quantities, steaming rice, warming food, melting chocolate or butter.

Low Melting large quantities.

Low-Medium Low-

temperature frying, simmering large quantities, heating milk, cream sauces,

gravies.

Medium

Sautéing and browning, braising, pan-frying, maintaining slow boil on large quantities.

Medium-Hi

High-temperature frying, pan boiling, maintaining slow boil on large quantities.

Hi Boiling liquid quickly, deep frying.

CAUTION Never leave pans on a high setting unattended. Be careful when cooking food in

fat or grease; it can become hot enough to ignite.

Simmer and Boil

A smaller flame will give the best results when simmering. Small flames offer precise cooking performance for

delicate foods, keeping food warm, melting chocolate or butter, and for cooking over low heat for long period of

time.

The highest (larger) flame settings provide the maximum heat that is available on your range. Thissetting should

be used for heavy cooking jobs such as boiling water and cooking pasts.

flame intensity

• When you adjust the flame intensity, watch the flame when you turn the knob.

• Any flame engulfs the cookware is wasted.

• The flame should stay steady and blue in color. Impurity in the gas supply may cause an orange flame during

initial operation.

Power Failure

• If the gas does not ignite within four seconds, turn off the valve and allow at least five minutes for any gas to

dissipate. Repeat the lighting procedure.

• In the event of a power failure, the surface burners can be lighted manually. Hold a lighted match near a burner

and turn the knob counterclockwise to “HI”. After burner lights, turn knob to the desired setting.

Burner Grills

1. The grills must be properly positioned before cooking. Improper installation

of the grills may result in scratching of the cooktop and / or poor combustion.

2. Do not operate the burners without a pan or utensil on the grills.

Griddle Operation (Only available on the 48” range)