Instruction Manual

1
=
A. Open the rear cover bar by removing the screws.
B. Use the open wrench to remove the screws from pipe connector.
C. Take out the 1.18 ULPG injector from the part bag and replace the 2.0 NG injector by the 1.18 ULPG injector.
D. Loosen the screws and adjust the diameter of the air inlet hole to 0.32”
E. Fix the pipe connector and the gas inlet by the screws.
F. Fix the rear cover bar by the screws
G. Install the back cover plate by the screws
Injector diameter for oven burners:
NG ---2.0 LPG --- 1.18
IMPORTANT: Keep the injectors removed from the range for future use.
STEP 5: Gas Valve
Back cover plate
Oven control