Installation Guide
11
IMPORTANT: DO NOT completely remove the rear leveling leg. The anti-tip bracket uses either the right-hand or left
1: Locate The Bracket
A.
NOTE: If bracket does not touch the rear wall, you MUST screw bracket to FLOOR .
B. Position the side of the bracket against either the left or right cabinet. If there is no adjacent cabinet, align the edge
bracket from the cabinet by the amount of overhang.
C. Mark the location for the pair of holes to be used (see illustration below).
NOTE: For FLOOR installation use either Loc A or B. For REAR WALL installation use Loc C.
2: Secure The Bracket
The bracket must be screwed to either the FLOOR or REAR WALL.
FLOOR Installation:
•
•
REAR WALL Installation:
Use the 2 screws provided to secure the bracket using the pair of marked holes at Loc C. The screws MUST enter a
Step 2: Imstall Anti-Tip Bracket (continued)
Adjacent cabinet
or final location of
range side panel
Attachment to floor or rear wall
Bracket
Wall sill plate
Loc
C
Loc
A
Loc
B
Two screws must
enter floor or wall
at Loc A,B, or C.
Rear Wall
The screw must
enter to wood or
concrete
The screw must enter to wood
3: Check The Bracket
TIP bracket as shown in Step 1. To check if the bracket is installed and engaged properly, look underneath the range
to see that the rear leveling leg is engaged in the bracket. On some models, the storage drawer or kick panel can be
is pulled from the wall for any reason, always repeat this procedure to verify the range is properly secured by the anti-tip
bracket.
NOTE: The anti-tip bracket must be PROPERLY INSTALLED, and the rear leveling leg must be FULLY ENGAGED into
secured to the ANTI-TIP bracket properly.